ok i went and bought this thing called ultra ATA/133. high speed dual channel ultra ATA/133 controller. its a pci card that comes with 2 IDE slots. i went to windows setup hit f6 put in the floppy and installed it. but yet it refuses to recognize my hard drive that i plugged into there. wtf???
also when i boot now it says: press f3 to enter config utility or somethin. i do that and it goes to this sscreen with this on it:
press f1 to assign first (HDD) set. and press f2 to remove it. i press f1 and it says to assign a number. waht do i type? i tried 1 and 2 and still no HD.


EDIT:
Well after doin some stuff and messin around with it i got it to recognize the hard drive and start doing the reformat. i deleted the partition, created a new partition, restarted and then formatted. and now once again its stuck at 0%... New HD?? btw, i did this using my pci slot thing i bought.

Twenty-eight days... six hours... forty-two minutes... twelve seconds. That, is when the world will end.